Lubricating oil may cause irritation to eyes or skin. In case lubricating oil comes in contact with eyes
or skin, immediately flush eyes with water, wash skin with soap and water. Wear protective goggles,
gloves, and clothing. Failure to comply may result in personnel injury or death.
Apply a thin film of lubricating oil to the sealing lip of the new oil seal (13) and contact surface of the shaft (10).
10. Install the new oil seal (13) in the pump body (1) with the spring loaded lip toward the gear end of the pump body.
11. Seat the oil seal (13) until the seal is flush with the water seal counterbore in the pump body (1).
12. Using arbor press and brass drift (12), press the bearing and shaft assembly into the pump body (1).
Place the pump body (1) on the arbor press, cover side down.
During installation of the shaft and bearing assembly, avoid contacting the oil seal with the
threaded shaft. damage to equipment may result.
Install the shaft (10) and bearing assembly inside the pump body (1).
Using arbor press and brass drift (12), press the shaft (10) and bearing assembly into the
pump body (1).