RUBBER HOSES WITH B-NUTS REMOVAL - Continued
Accidental or intentional introduction of liquid contaminants into the environment
may result in a violation of state, federal, and military regulations. Refer to local
environmental office for information concerning storage, use, and disposal of
these liquids. Failure to comply may cause damage to environment and health
of personnel. Seek medical attention in the event of injury.
Fuel/solvent/oil is slippery and may cause falls. Wipe up spillage immediately with
rags. Dispose of materials in accordance with local hazardous waste disposal
procedures. Failure to comply may result in personnel injury or death and/or
damage to equipment.
Remove B-nut (Figure 2, Item 1) by hand and remove hose (Figure 2, Item 2) from connection point.
Drain residual coolant into drain pan.
Clean up spilled fluid with a spill clean-up kit and dispose of spill clean-up kit waste in accordance with local
END OF TASK
RUBBER HOSES WITH B-NUT INSTALLATION
Thread B-nut (Figure 2, Item 1) onto both connecting points hand tight.
Do not over tighten B-nut or damage to fitting threads may occur.
Tighten B-nut (Figure 2, Item 1) onto connecting points at both ends.
Figure 2. B-Nut Hose.
END OF TASK