• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
Lube oil dipstick tube assembly removed
Remove four cap screws and washers from flywheel housing

TECHNICAL MANUAL FIELD AND SUSTAINMENT MAINTENANCE MANUAL FOR ENGINE 8V92TA
Page Navigation
  356    357    358    359    360  361  362    363    364    365    366  
img
.
TM 55-2815-574-24
0072
WARNING
Keep away from hanging loads, heavy parts, and overhead equipment. Never crawl under
equipment when performing maintenance unless equipment is securely blocked. Use
suitable lifting devices to move hanging loads and heavy parts. Equipment may fall. Always
use a helper to guide load. Failure to comply may result in personnel injury or death.
REMOVAL
1.
Install two lifting eye bolts in flywheel housing (Figure 1, Item 1).
2.
Support flywheel housing (Figure 1, Item 1) with a crane, slings and shackles from lifting eye bolts.
NOTE
Do not reuse the old cap screws that secure the flywheel housing to the engine block in
this task, tag and mark all screws and bolts throughout this task so that they may be
matched with new cap screws to be installed in their proper location.
3.
Remove two cap screws (Figure 1, Item 2), lockwashers (Figure 1, Item 3), flat washers (Figure 1, Item 4)
and left bank bracket (Figure 1, Item 5). Discard lockwashers.
4.
Remove two cap screws (Figure 1, Item 6), lockwashers (Figure 1, Item 7), flat washers (Figure 1, Item 8)
and right bank bracket (Figure 1, Item 9). Discard lockwashers.
5.
Remove six cap screws (Figure 1, Item 10) and washers (Figure 1, Item 11) from flywheel housing
(Figure 1, Item 1).
Figure 1.
0072-3


Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.