HONE THE CYLINDER LINER Continued
Keep hands, fingers and clothing away from moving parts.
Wear protective goggles. Failure to comply may result in personnel injury.
2. Work body, cylinder hone with stones, abrasive, cylinder hone up and down the full length of the liner (2) at
300 to 400 RPM's.
Upon completion of the honing the cylinder liner should have a criss-cross pattern of marks at
a 45° axis.
Measure the cylinder liners (2) using a gage, cylinder, setting master, dial bore gage and master ring gage.
X - LONGITUDUNAL AXIS
(LENGTHWISE OF ENGINE)
Y - TRANSVERSE AXIS
(CROSSWISE OF ENGINE)
1 3/4 "
LINER AT PLACES
A, B, C, D, E, F
AND G ON "X" AND
Measure the inside bore of the cylinder liner at (A, B, C, D, E, F and G) on both the (X) and (Y) axis.