TM 55-2815-574-24
0032
INSTALLATION - Continued
32.
Position U-joint bolt (Figure 32, Item 6) beneath CO2 supply line (Figure 32, Item 7) and install on propulsion
module frame cross-member support bracket (Figure 32, Item 8).
33.
Secure U-joint bolt (Figure 32, Item 6) to propulsion module frame cross-member support bracket (Figure
32, Item 8) with two nuts (Figure 32, Item 4) and tighten nuts.
34.
Using a pipe wrench, connect pipe coupling (Figure 32, Item 5) to CO2 supply line
(Figure 32, Item 7) that feeds fire suppression trip mechanism solenoid (Figure 32, Item 2) near propulsion
module frame cross-member support bracket (Figure 32, Item 8).
35.
Install one bolt (Figure 32, Item 1) and nut (Figure 32, Item 12) to secure fire suppression trip mechanism
solenoid (Figure 32, Item 2) to its mount.
Figure 32. Fire Suppression System Installation.
END OF TASK
FOLLOW-ON MAINTENANCE
1.
Install marine gear oil pump (TM 55-1925-319-23).
2.
Install hydraulic pump (TM 55-1925-205-23).
3.
Vent hydraulic system pressure (TM 55-1925-205-23).
4.
Adjust hydraulic system pressure (TM 55-1925-205-23).
5.
Adjust hydraulic system flow (TM 55-1925-205-23).
6.
Fill the fresh water cooling system (TM 55-1925-205-10).
7.
Install fast lube system (TM 55-1925-205-23).
8.
Fill engine with crankcase oil (WP 0115).
9.
Install marine gear to transfer case driveshaft (TM 55-1925-205-23).
10.
Install marine gear to transfer case machinery guards (TM 55-1925-205-23).
11.
Install exhaust system (TM 55-1925-205-23).
12.
Install engine hatch (TM 55-1925-205-23).
13.
Install operator`s cab or air intake plenum (TM 55-1925-205-23).
14.
Install main navigation mast (TM 55-1925-205-23).
