TM 55-2815-574-24
0163
REMOVAL - Continued
3.
Lift up and slide back four insulators (Figure 2, Item 11) from starter relay terminals (Figure 2, Item 13).
4.
Remove four nuts (Figure 2, Item 9), lockwashers (Figure 2, Item 8), and washers (Figure 2, Item 7) from
starter relay terminals (Figure 2, Item 13).
5.
Tag four wires (Figure 2, Items 10, 12, 14, and 15).
6.
Remove four wires (Figure 2, Items 10, 12, 14, and 15) from starter relay terminals (Figure 2, Item 13).
7.
Remove two hex bolts (Figure 2, Item 4) and lockwashers (Figure 2, Item 3) holding mounting bracket
(Figure 2, Item 2) to engine block (Figure 2, Item 1).
8.
Remove two bolts (Figure 2, Item 6), lockwashers (Figure 2, Item 5), and nuts (Figure 2, Item 17) from
starter relay (Figure 2, Item 16) and mounting bracket (Figure 2, Item 2).
9.
Remove starter relay (Figure 2, Item 16). Discard starter relay.
END OF TASK
INSTALLATION
1.
Install two nuts (Figure 2, Item 17), lockwashers (Figure 2, Item 5), and bolts (Figure 2, Item 6) to new
starter relay (Figure 2, Item 16) and mounting bracket (Figure 2, Item 2).
2.
Install two lockwashers (Figure 2, Item 3) and hex bolts (Figure 2, Item 4) to mounting bracket
(Figure 2, Item 2) and engine block (Figure 2, Item 1).
3.
Connect four wires (Figure 2, Items 10, 12, 14, and 15) to starter relay terminals (Figure 2, Item 13).
4.
Install four washers (Figure 2, Item 7), lockwashers (Figure 2, Item 8), and nuts (Figure 2, Item 9) to starter
relay terminals (Figure 2, Item 13).
5.
Tighten nuts (Figure 2, Item 9).
6.
Slide four insulators (Figure 2, Item 11) over starter relay terminals (Figure 2, Item 13).
0163-2
