TM 55-2815-574-24
SUSTAINMENT MAINTENANCE
ENGINE
CRANKSHAFT REAR OIL SEAL REPLACEMENT
INITIAL SETUP:
Tools and Special Tools
Equipment Condition (cont.)
General mechanic's tool kit
Exhaust manifolds removed (WP 0157)
(WP 0179, Table 1, Item 130)
Marine gear oil cooler removed
Chemical gloves (WP 0179, Table 1, Item 52)
(TM 55-2040-211-24)
Drift pin (WP 0179, Table 1, Item 90)
Fuel cooler removed (WP 0081)
Driver handle (WP 0179, Table 1, Item 62)
Air box covers removed (WP 0036)
Industrial goggles (WP 0179, Table 1, Item 54)
Air box drains removed (WP 0037)
Seal installer (WP 0179, Table 1, Item 73)
Starting motor removed (WP 0164)
Lube oil level dipstick tube assembly removed
Materials/Parts
Overspeed governor removed (WP 0169)
(
Engine lubricating oil, 30W
Marine gear oil cooler mounting bracket removed
WP 0178, Table 1, Item 25)
Oil seal (WP 0180, Table 1, Item 118)
Lube oil cooler removed (WP 0128)
(
Wooden block Qty: 2
Engine installed on stand (WP 0033)
WP 0178, Table 1, Item 27)
Electrical system hour meter removed (WP 0161)
Electrical system hour meter mounting bracket
removed (WP 0162)
Personnel Required
Raw water pump removed (WP 0155)
Engineer 88L
Electronic governor magnetic pick-up removed
Equipment Condition
Lube oil pan removed (WP 0127)
Crankcase breather limiter assembly removed
Flywheel removed (WP 0070)
Flywheel housing removed (WP 0072)
Air inlet collector assembly removed (WP 0104)
Turbochargers removed (WP 0114)
0062-1
