TROUBLESHOOTING PROCEDURES - ELECTRONIC GOVERNOR GOES TO FULL STROKE WHEN DC
POWER IS APPLIED AND ENGINE IS NOT OPERATING
Tools and Special Tools
General mechanic's tool kit
This following procedure is typical for both port and starboard engines.
ELECTRONIC GOVERNOR GOES TO FULL STROKE WHEN DC POWER IS APPLIED
AND ENGINE IS NOT OPERATING
Electronic governor actuator goes to full stroke when Direct Current (DC) power is applied and engine
is not operating.
Magnetic pick-up leads not shielded.
Verify magnetic pick-up leads are shielded. If they are not, correct wiring as necessary
Perform operational check of the electronic governor actuator (TM 55-1925-205-10).
Damaged magnetic pick-up coil.
Replace electronic governor magnetic pick-up (WP 0100).