• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
Earthmover  Tire  Repair
Cold Patches

Equipment Operator Basic - Beginning construction equipment operators manual
Page Navigation
  64    65    66    67    68  69  70    71    72    73    74  
holds the hydraulic ram and shoe assembly. When device in place with one hand and tighten the large securing the clamping device (fig. 3-34) to the rim, clamping screw lightly. Swing the reaction screw, as release  the  primary  clamping  device  to  permit  full shown,  until  it  is  approximately  perpendicular  to  the opening of the jaws. Hold the clamping device in a side of the rim flange. Turn the reaction screw in to bring vertical position, as shown. Then hold the clamping the clamping device perpendicular to the rim. Tighten Figure 3-34.—Clamping device. Figure 3-35.—Hydraulic cylinder and shoe. 3-18







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.