TM 55-2815-574-24
0094
INSTALLATION
1.
Install new gasket (Figure 3, Item 2) on governor housing (Figure 3, Item 1).
NOTE
Fuel pump must be installed with inlet opening in pump cover marked "L.H. IN" positioned
next to balance weight cover.
2.
Install fuel pump (Figure 3, Item 8) on governor housing (Figure 3, Item 1) ensuring that coupling fork
(Figure 3, Item 3) aligns with slots in drive disc (Figure 3, Item 10).
3.
Install three nylon patch bolts (Figure 3, Item 4) to secure fuel pump (Figure 3, Item 8) to governor housing
(Figure 3, Item 1). Tighten bolts.
4.
Connect outlet port fuel line (Figure 3, Item 7) to outlet port elbow (Figure 3, Item 6) on fuel pump
(Figure 3, Item 8). Tighten fuel line.
5.
Connect inlet fuel line (Figure 3, Item 9) to inlet port elbow (Figure 3, Item 5) on fuel pump (Figure 3, Item 8).
Tighten fuel line.
CAUTION
Fuel pump must be primed after installation. Failure to comply may result in fuel pump
seizing after initial start.
6.
Prime fuel pump (WP 0078).
7.
Dispose of fuel soaked cleaning cloths in accordance with local procedure.
END OF TASK
FOLLOW-ON MAINTENANCE
1.
Install heat exchanger (WP 0134).
2.
Install engine hatch (TM 55-1925-205-23).
3.
Install operator's cab (TM 55-1925-205-23).
4.
Install intake plenum assembly (TM 55-1925-205-23).
5.
Install main navigation mast (TM 55-1925-205-23).
6.
Install SINCGARS antenna (TM 11-5820-890-10-8).
7.
Perform operational check of diesel engine (TM 55-1925-205-10).
END OF TASK
END OF WORK PACKAGE
0094-5/blank
