4-64.The engine lathe in a machine shopshould NOT be used for which of thefollowing jobs?1.Turning and boring2.Facing and thread cutting3.Drilling and grinding4.Bending and shaping4-65.In ships with a one latheallowance, what is usually the sizeof the lathe?1.14 in.2.16 in.3.18 in.4.20 in.4-66.When an engine lathe is used formilling, the workpiece is usuallymounted on which of the followinglathe parts?1.Headstock2.Tailstock spindle3. Carriage4. Faceplate4-67.On an engine lathe, which of thefollowing operations is usuallyperformed with the carriage lockedin position?1. Turning2. Facing3. Boring4.Drilling4-68.Gears in the apron of an enginelathe are driven by which of thefollowing lathe parts?1.Control rod2. Lead rod3. Reverse rod4.Feed rod4-69.Which of the following cutter bitsis sometimes ground flat on top soit may be fed in both directions?4-70.What type of lathe chuck can beused to automatically center roundworkpieces of many sizes?1.Scroll chuck2.4-jaw chuck3. Standard collet chuck4.Hexagonal collet chuck4-71.A carriage stop may be used on anengine lathe to eliminate the needfor which of the following actions?1.Individual measurements ofduplicate parts2.Manually shutting off theautomatic feed3. Setup measurements madedirectly on the workpiece4. Variable rates of feed across aworkpiece4-72.Which of the following lubricantsis to be used for general machinework on brass or Monel rods?1. Mineral lard oil2.Turpentine3. Soluble oil4.White lead4-73.What lathe accessory is used formounting odd-shaped workpieces thatcannot be turned between centers?1. Mandrel2.3-jaw chuck3. Collet chuck4. Faceplate4-74.A depth of cut of 0.040 inchreduces the diameter of a latheworkpiece by what measurement?1.0.020 in.2.0.040 in.3.0.080 in.4.0.120 in.1. Left-hand turning tool2.Right-hand facing tool3. Square-nosed parting tool4. Round-nosed turning tool33
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business