TM 55-2815-574-24
0063
DISASSEMBLE Continued
5.
Remove six lock rings (29) and three intermediate cam bearing sets (30) from camshafts (10 and 11).
29
30
10
11
30
END OF TASK
ASSEMBLE
WARNING
Accidental or intentional introduction of liquid contaminants into the environment may result in a
violation of state, federal, and military regulations. Refer to local environmental office for information
concerning storage, use, and disposal of these liquids. Failure to comply may result in personnel injury
and/or damage to environment.
Fuel/solvent/oil is slippery and may cause falls. Wipe up spillage immediately with rags. Dispose of
materials in accordance with local hazardous waste disposal procedures. Failure to comply may result in
personnel injury or death and/or damage to equipment.
NOTE
This procedure is typical for both camshafts.
1. Apply grease to the steel faces of the thrust washers (28).
10
11
28
27
2.
Apply engine oil to cam shaft (10 and 11) rear bearing journal.
0063-6