Figure 9-11 .—Control levers.
at the same time with any other four positions. Also,
most loaders have a position indicator and depth gauge
indicator mounted on the bucket.
To set the multipurpose attachment as a bucket, the
operator pulls the control lever back (fig. 9-11) until the
Figure 9-12.—Multiltipurpose bucket set in “bucket” position.
Figure 9-13.—Multipurpose bucket set in “scraper” position.
clamshell indicator is at the “O” setting on the clam
product graphic (fig. 9-12).
To set the multipurpose bucket as a scraper, you
open the clamshell until the indicator points to 2 or 4 on
the clam product graphic (fig. 9-13). The more the
clamshell is open, the deeper a cut can be made.
To use the multipurpose bucket as a dozer, you open
the clamshell until the clamshell indicator is at the
bottom of the clam product graphic (fig. 9-14).
When using the multipurpose blade as a dozer, you
can adjust the amount of cut by the pitch of the dozer
Figure 9-14.—Multipurpose bucket set in “dozer” position.
9-7
