ASSEMBLE - Continued
The steel faces of the thrust washers are to be placed next to the bearings.
Install new thrust washers (28), a new cam bearing (27) and then other new thrust washer (28) on
camshaft (10 and 11).
Install a new woodruff key (26) in the keyway on camshafts (10 and 11).
Using an arbor press, press the gears (4 and 8) onto camshafts (10 and 11).
Install nuts (9) onto camshafts (10 and 11) finger tight.
Accidental or intentional introduction of liquid contaminants into the environment may result in a
violation of state, federal, and military regulations. Refer to local environmental office for information
concerning storage, use, and disposal of these liquids. Failure to comply may result in personnel injury
and/or damage to environment.
Fuel/solvent/oil is slippery and may cause falls. Wipe up spillage immediately with rags. Dispose of
materials in accordance with local hazardous waste disposal procedures. Failure to comply may result in
personnel injury or death and/or damage to equipment.
7. Apply engine oil onto intermediate cam bearing journals on camshafts (10 and 11).