TM 55-2815-574-24
0062
INSTALLATION
WARNING
Oils and fluids are flammable and may cause irritation to the eyes or skin. Use in well-
ventilated areas and keep away from heat and open flame. Wear protective goggles and
clothing. In case oil or fluid comes in contact with:
Eyes, flush immediately with water.
Skin, wash with soap and water.
Failure to comply may result in personnel injury or death.
1.
Lubricate outside edge of new oil seal (Figure 2, Item 3) with engine lubricating oil.
2.
Using seal installer J 21112-B (Figure 2, Item 2), driver handle J-3154-1A, and ball peen hammer, install
new oil seal (Figure 2, Item 3) into flywheel housing (Figure 2, Item 1).
Figure 2. Rear Crankshaft Oil Seal Installation.
END OF TASK