TM 55-2815-574-24
0072
WARNING
Keep away from hanging loads, heavy parts, and overhead equipment. Never crawl under
equipment when performing maintenance unless equipment is securely blocked. Use
suitable lifting devices to move hanging loads and heavy parts. Equipment may fall. Always
use a helper to guide load. Failure to comply may result in personnel injury or death.
REMOVAL
1.
Install two lifting eye bolts in flywheel housing (Figure 1, Item 1).
2.
Support flywheel housing (Figure 1, Item 1) with a crane, slings and shackles from lifting eye bolts.
NOTE
Do not reuse the old cap screws that secure the flywheel housing to the engine block in
this task, tag and mark all screws and bolts throughout this task so that they may be
matched with new cap screws to be installed in their proper location.
3.
Remove two cap screws (Figure 1, Item 2), lockwashers (Figure 1, Item 3), flat washers (Figure 1, Item 4)
and left bank bracket (Figure 1, Item 5). Discard lockwashers.
4.
Remove two cap screws (Figure 1, Item 6), lockwashers (Figure 1, Item 7), flat washers (Figure 1, Item 8)
and right bank bracket (Figure 1, Item 9). Discard lockwashers.
5.
Remove six cap screws (Figure 1, Item 10) and washers (Figure 1, Item 11) from flywheel housing
(Figure 1, Item 1).
Figure 1.