TM 55-2815-574-24
FIELD MAINTENANCE
ENGINE
FRESH WATER COOLING SYSTEM PUMP REPLACEMENT
INITIAL SETUP:
Tools and Special Tools
Materials/Parts (cont.)
General mechanic's tool kit
Lockwasher Qty: 5 (WP 0180, Table 1, Item 3)
(WP 0179, Table 1, Item 130)
Ring seal (WP 0180, Table 1, Item 32)
Air filtering respirator (WP 0179, Table 1, Item 109)
Chemical gloves (WP 0179, Table 1, Item 52)
Personnel Required
Dial indicator (WP 0179, Table 1, Item 67)
Engineer 88L
Industrial goggles (WP 0179, Table 1, Item 54)
Machine bolt (WP 0179, Table 1, Item 13)
Socket wrench set (3/8 in. sqdr.)
References
(WP 0179, Table 1, Item 135)
TM 55-1925-205-10
Torque Wrench, 3/8 in. drive,
150750 in-lb
Equipment Condition
(WP 0179, Table 1, Item 142)
Fresh water filter removed (WP 0136)
Utility apron (WP 0179, Table 1, Item 8)
Fresh water cooling system drained (WP 0133)
Fresh water cooling system heat exchanger
Materials/Parts
removed (WP 0134)
Gasket (WP 0180, Table 1, Item 48)
Fuel system filter removed (WP 0079)
WARNING
Accidental or intentional introduction of liquid contaminants into the environment
may result in a violation of state, federal, and military regulations. Refer to local
environmental office for information concerning storage, use, and disposal of
these liquids. Failure to comply may cause damage to environment and health
of personnel. Seek medical attention in the event of injury.
Fuel/solvent/oil is slippery and may cause falls. Wipe up spillage immediately with
rags. Dispose of materials in accordance with local hazardous waste disposal
procedures. Failure to comply may result in personnel injury or death and/or
damage to equipment.
0147-1