TM 55-2815-574-24
0115
DRAINING LUBE OIL SYSTEM CRANKCASE - Continued
3.
Remove dust cap (Figure 2, Item 1) from forward coupling half (Figure 2, Item 2).
4.
Position FLOCS cart within 48 in. (122 cm) of forward coupling half (Figure 2, Item 2).
5.
Connect a combination of hose coupling and pipe nipple to end of pump discharge hose.
6.
Place end of pump discharge hose inside a dirty oil storage drum placed within 48 in. (122 cm) of
FLOCS cart.
7.
Connect FLOCS cart pump suction hose to forward coupling half (Figure 2, Item 2).
8.
Connect pump electrical cord to 115 VAC shore outlet.
NOTE
To stop pump in an emergency, depress the emergency stop button. The emergency stop
button must be reset to restart the pump. To reset, pull emergency stop button out.
9.
Turn on pump. A green signal light will indicate pump is running and will turn off upon completion of
oil evacuation.
WARNING
Do not allow any oil/fuel to drip onto deck. Failure to comply may result in
personnel injury.
Accidental or intentional introduction of liquid contaminants into the environment
may result in a violation of state, federal, and military regulations. Refer to local
environmental office for information concerning storage, use, and disposal of
these liquids. Failure to comply may cause damage to environment and health
of personnel. Seek medical attention in the event of injury.
10.
Disconnect end of FLOCS cart pump section hose from forward coupling half (Figure 2, Item 2) and wipe
clean with spill clean-up kit.
11.
Dispose of used oil and spill clean-up kit waste in accordance with local procedures.
END OF TASK
1.
Connect a combination hose coupling and pipe nipple to end of pump suction hose.
2.
Place end of pump suction hose inside clean engine lubricating oil storage drum placed within
48 in. (122 cm) of FLOCS cart.
NOTE
To stop pump in an emergency, depress the emergency stop button. The emergency stop
button must be reset to restart the pump. To reset, pull emergency stop button out.
3.
Turn on pump.
4.
Operate pump for approximately 60 seconds to pull clean oil through and flush pump suction hose.
5.
Stop pump.
6.
Remove end of pump discharge hose inside dirty oil storage drum and wipe clean with spill clean-up kit.