TM 55-2815-574-24
0172
REMOVAL - Continued
3.
Tag and disconnect wires (Figure 2, Item 1) from oil pressure switch (Figure 2, Item 3).
WARNING
Accidental or intentional introduction of liquid contaminants into the environment
may result in a violation of state, federal, and military regulations. Refer to local
environmental office for information concerning storage, use, and disposal of
these liquids. Failure to comply may cause damage to environment and health
of personnel. Seek medical attention in the event of injury.
Fuel/solvent/oil is slippery and may cause falls. Wipe up spillage immediately with
rags. Dispose of materials in accordance with local hazardous waste disposal
procedures. Failure to comply may result in personnel injury or death and/or
damage to equipment.
4.
Position drain pan below oil pressure switch (Figure 2, Item 3).
5.
Remove oil pressure switch (Figure 2, Item 3) from engine block elbow (Figure 2, Item 2).
END OF TASK
INSTALLATION
1.
Wrap threads of new oil pressure switch (Figure 2, Item 3) with antiseizing tape.
WARNING
Accidental or intentional introduction of liquid contaminants into the environment
may result in a violation of state, federal, and military regulations. Refer to local
environmental office for information concerning storage, use, and disposal of
these liquids. Failure to comply may cause damage to environment and health
of personnel. Seek medical attention in the event of injury.
Fuel/solvent/oil is slippery and may cause falls. Wipe up spillage immediately with
rags. Dispose of materials in accordance with local hazardous waste disposal
procedures. Failure to comply may result in personnel injury or death and/or
damage to equipment.
2.
Install switch (Figure 2, Item 3) in engine block elbow (Figure 2, Item 2).
3.
Remove drain pan and dispose of contents in accordance with local procedures.
4.
Clean up spilled fluid with a spill clean-up kit and dispose of spill clean-up kit waste in accordance with local
procedures.
5.
Connect wires (Figure 2, Item 1) to oil pressure switch (Figure 2, Item 3).
6.
Remove tags from wires (Figure 2, Item 1).
0172-2