TM 55-2815-574-24
0040
INSTALLATION
WARNING
Sealing compound may cause irritation to the eyes or skin. Use in well-ventilated area.
Wear protective goggles and clothing. In case sealing compound comes in contact with:
Eyes, flush immediately with water.
Skin, wash with soap and water.
Failure to comply may result in personnel injury.
1.
Coat rear end plate (Figure 2, Item 4) and engine block (Figure 2, Item 1) with sealing compound.
2.
Install new gasket (Figure 2, Item 3) on engine block (Figure 2, Item 1) over dowel pins (Figure 2, Item 2).
3.
Install rear end plate (Figure 2, Item 4) on engine block (Figure 2, Item 1).
Figure 2. Rear End Plate Gasket.
4.
Install four hex head screws (Figure 1, Item 10) and lockwashers (Figure 1, Item 11) in rear end plate
(Figure 1, Item 1) finger tight.
5.
Install hex head screw (Figure 1, Item 4) and lockwasher (Figure 1, Item 3) in rear end plate
(Figure 1, Item 1) finger tight.
6.
Install cam bearings (Figure 1, Item 2) on rear end plate (Figure 1, Item 1).
7.
Install six lockwashers (Figure 1, Item 5) and cap screws (Figure 1, Item 6) on cam bearings
(Figure 1, Item 2).
8.
Install right-hand dummy bearing (Figure 1, Item 9) on end plate (Figure 1, Item 1).