TM 55-2815-574-24
0069
DISASSEMBLE Continued
8.
Remove bearings (6) from idler gear (4).
6
4
9
8
6
8
9.
Remove inner spacer ring (7) from hub (6).
10. Support idler gear (4) with wooden blocks.
CAUTION
Do not remove the bearing cups unless the bearings and bearing cups are to be replaced.
Failure to comply may result in damage to equipment.
11. Using a brass drift and a hammer, tap the bearing cups (8) and spacer rings (9) out of idler gear (4).
END OF TASK
CLEAN
WARNING
Cleaner may cause irritation to eyes or skin. In case cleaner comes in contact with eyes or skin,
immediately flush eyes with water, wash skin with soap and water. Wear protective goggles, gloves,
and clothing. Failure to comply may result in personnel injury or death.
1.
Clean all parts thoroughly using cleaning compound and cleaning cloth.
WARNING
Do not exceed 40 PSI (276 kPa) when using compressed air for drying components.
Failure to comply could result in serious injury to personnel.
2.
Dry all parts thoroughly with compressed air.
END OF TASK
0069-3