TM 55-2815-574-24
0156
DISASSEMBLY - Continued
7.
Using retaining ring pliers, remove snap ring (Figure 2, Item 3).
8.
Insert two wires, each bent to a hook at one end, between housing (Figure 2, Item 2) and shaft seal
(Figure 2, Item 1) assembly with hooks over the edge of carbon seal (Figure 2, Item 5) and pull seal
assembly from shaft (Figure 2, Item 4).
9.
Repeat Step 8 to remove seal seat (Figure 2, Item 6) and gasket (Figure 2, Item 7).
Figure 2. Seal Seat and Gasket.
10.
Place housing (Figure 3, Item 5) with drive gear (Figure 3, Item 3) in vise equipped with soft jaw vise caps.
11.
Remove hex nut (Figure 3, Item 1) and lockwasher (Figure 3, Item 2). Discard lockwasher.
12.
Remove drive gear (Figure 3, Item 3) from the vise.
13.
Using puller set, remove drive gear (Figure 3, Item 3) from shaft (Figure 3, Item 6).
14.
Remove woodruff key (Figure 3, Item 4) from shaft (Figure 3, Item 6).
Figure 3. Drive Gear.