TM 55-2815-574-24
0081
REMOVAL - Continued
2.
Verify butterfly valve (Figure 2, Item 1) on seachest is off.
Figure 2. Butterfly Valve.
3.
Position a drain pan under fuel cooler (Figure 3, Item 3).
4.
Remove four clamps (Figure 3, Item 1) from two hoses (Figure 3, Item 2).
5.
Remove two hoses (Figure 3, Item 2) from fuel cooler (Figure 3, Item 3) and allow raw water to drain
into the bilge.
WARNING
Accidental or intentional introduction of liquid contaminants into the environment
may result in a violation of state, federal, and military regulations. Refer to local
environmental office for information concerning storage, use, and disposal of
these liquids. Failure to comply may cause damage to environment and health
of personnel. Seek medical attention in the event of injury.
Fuel/solvent/oil is slippery and may cause falls. Wipe up spillage immediately with
rags. Dispose of materials in accordance with local hazardous waste disposal
procedures. Failure to comply may result in personnel injury or death and/or
damage to equipment.
6.
Remove two clamps (Figure 3, Item 4) from two fresh water coolant hoses (Figure 3, Item 5).
7.
Remove two fresh water coolant hoses (Figure 3, Item 5) from fuel cooler (Figure 3, Item 3) and allow fresh
water to drain into the drain pan.