TM 55-2815-574-24
0128
INSTALLATION - Continued
Figure 13. Mounting Hardware Installation.
19.
Install new seal (Figure 14, Item 2) on oil cooler housing (Figure 14, Item 1).
20.
Slide clamp (Figure 14, Item 3) over elbow (Figure 14, Item 4) and seal (Figure 14, Item 2).
21.
Tighten clamp (Figure 14, Item 3).
Figure 14. Water Outlet Elbow Installation.
22.
Install new gasket (Figure 15, Item 6) and position water inlet elbow (Figure 15, Item 4) on oil cooler
housing (Figure 16, Item 7).
23.
Install four bolts (Figure 15, Item 5) through water inlet elbow (Figure 15, Item 4) and gasket
(Figure 15, Item 6) into oil cooler housing (Figure 15, Item 7).
24.
Tighten four bolts (Figure 15, Item 5).
25.
Install hose (Figure 15, Item 3) and slide two clamps (Figure 15, Item 2) in place on
hose (Figure 15, Item 3).
26.
Tighten two clamps (Figure 15, Item 2).
27.
Connect oil temperature switch electrical connector (Figure 15, Item 9).
28.
Connect oil filter supply line (Figure 15, Item 1) and return line (Figure 15, Item 8).
29.
Remove LO/TO from A3 breaker switch. Refer to FM 4-01.502 for LO/TO procedure.