TM 55-2815-574-24
0139
FOLLOW-ON MAINTENANCE
WARNING
Accidental or intentional introduction of liquid contaminants into the environment
may result in a violation of state, federal, and military regulations. Refer to local
environmental office for information concerning storage, use, and disposal of
these liquids. Failure to comply may cause damage to environment and health
of personnel. Seek medical attention in the event of injury.
Fuel/solvent/oil is slippery and may cause falls. Wipe up spillage immediately with
rags. Dispose of materials in accordance with local hazardous waste disposal
procedures. Failure to comply may result in personnel injury or death and/or
damage to equipment.
1.
Clean up spilled fluid with spill clean-up kit and dispose of spill clean-up kit waste in accordance with local
procedures.
2.
Install fresh water cooling system bypass tube (WP 0143).
3.
Install fuel system block (WP 0085).
4.
Install cold start temperature switch (WP 0166).
5.
Install fuel oil pressure switch (WP 0173).
6.
Install electrical system engine normal stop pushbutton mounting bracket (WP 0160).
7.
Install electrical system engine normal stop pushbutton (WP 0159).
8.
Service fresh water cooling system (TM 55-1925-205-10).
9.
Install engine deck hatch (TM 55-1925-205-23).
10.
Install powered section exhaust plenum (TM 55-1925-205-23).
11.
Install powered section intake plenum assembly (TM 55-1925-205-23).
12.
Install powered section operator's cab (TM 55-1925-205-23).
13.
Install SINCGARS antenna (TM 11-5820-890-10-8).
14.
Install main navigation mast (TM 55-1925-205-23).
15.
Perform operational check of diesel engine (TM 55-1925-205-10).
END OF TASK
END OF WORK PACKAGE
0139-7/blank