TM 55-2815-574-24
FIELD MAINTENANCE
ENGINE
FRESH WATER COOLING SYSTEM BYPASS HOSES REPLACEMENT
INITIAL SETUP:
Tools and Special Tools
Equipment Condition (cont.)
General mechanic's tool kit
Single channel ground and airborne radio system
(WP 0179, Table 1, Item 130)
(SINCGARS) antenna removed
Air filtering respirator (WP 0179, Table 1, Item 109)
(TM 11-5820-890-10-8)
Chemical gloves (WP 0179, Table 1, Item 52)
Powered section operator's cab removed
Industrial goggles (WP 0179, Table 1, Item 54)
(TM 55-1925-205-23)
Powered section intake plenum assembly
removed (TM 55-1925-205-23)
Personnel Required
Engine hatch removed (TM 55-1925-205-23)
Engineer 88L
Engine cool to touch
Fresh water cooling system drained
(TM 55-1925-205-10)
Equipment Condition
Main navigation mast removed
(TM 55-1925-205-23)
WARNING
Accidental or intentional introduction of liquid contaminants into the environment
may result in a violation of state, federal, and military regulations. Refer to local
environmental office for information concerning storage, use, and disposal of
these liquids. Failure to comply may cause damage to environment and health
of personnel. Seek medical attention in the event of injury.
Fuel/solvent/oil is slippery and may cause falls. Wipe up spillage immediately with
rags. Dispose of materials in accordance with local hazardous waste disposal
procedures. Failure to comply may result in personnel injury or death and/or
damage to equipment.
NOTE
The following procedure is typical for both port and starboard engines.
0143-1