TM 55-2815-574-24
0101
INSTALLATION - Continued
5.
Slide hoses (Figure 2, Item 6) down tubes (Figure 2, Item 1) overlapping both tubes and governor drive
(Figure 2, Item 4).
6.
Install clamps (Figure 2, Item 5) on hoses (Figure 2, Item 6).
Figure 2. Governor Drive.
7.
Install cotter pins (Figure 1, Item 2) and clevis pins (Figure 1, Item 4) on fuel rods (Figure 1, Item 1) and
injector rack clevises (Figure 1, Item 3).
END OF TASK
FOLLOW-ON MAINTENANCE
1.
Install electronic governor actuator (WP 0098).
2.
Install electronic governor rod assembly (WP 0097).
3.
Install blower shaft and spring assembly (WP 0109).
4.
Install tachometer signal generator (sending unit) (WP 0167).
5.
Install fuel pump (WP 0094).
6.
Install fresh water cooling system bypass tube (WP 0143).
7.
Install cylinder head poppet valve rocker arm covers (WP 0049).
8.
Install air inlet collector assembly (WP 0104).
9.
Install crankcase breather limiter assembly (WP 0106).
10.
Service fresh water cooling system (TM 55-1925-205-10).
11.
Install powered section engine hatch (TM 55-1925-205-23).
12.
Install operator's cab (TM 55-1925-205-10).