TM 55-2815-574-24
0102
DISASSEMBLY
1.
Loosen cap screw (Figure 1, Item 11) securing remote control lever (Figure 1, Item 12) to shaft and lever
assembly (Figure 1, Item 2).
2.
Remove remote control lever (Figure 1, Item 12) from shaft and lever assembly (Figure 1, Item 2).
3.
Remove woodruff key (Figure 1, Item 13) from shaft and lever assembly (Figure 1, Item 2).
4.
Using snap ring pliers, remove retaining ring (Figure 1, Item 10) from shaft and lever assembly
(Figure 1, Item 2). Discard retaining ring.
5.
Remove two flat washers (Figure 1, Item 9) and seal ring (Figure 1, Item 8) from shaft and lever assembly
(Figure 1, Item 2). Discard seal ring.
6.
Remove two pins (Figure 1, Item 4) and washers (Figure 1, Item 3) from shaft and lever assembly
(Figure 1, Item 2).
7.
Remove two fuel rods (Figure 1, Item 6) from shaft and lever assembly (Figure 1, Item 2).
8.
Slide shaft and lever assembly (Figure 1, Item 2) from housing (Figure 1, Item 5).
9.
Using arbor press, press out two tubes (Figure 1, Item 1) from housing (Figure 1, Item 5).
10.
Using arbor press, press out bearing (Figure 1, Item 7) from housing (Figure 1, Item 5). Discard bearing.
Figure 1. Electronic Governor Drive Assembly.
END OF TASK