TM 55-2815-574-24
0102
ASSEMBLY
1.
Using arbor press, press new bearing (Figure 1, Item 7) in housing (Figure 1, Item 5).
2.
Using arbor press, press two tubes (Figure 1, Item 1) in housing (Figure 1, Item 5).
3.
Position shaft and lever assembly (Figure 1, Item 2) in housing (Figure 1, Item 5).
4.
Install new seal ring (Figure 1, Item 8) on shaft of shaft and lever assembly (Figure 1, Item 2).
5.
Install two flat washers (Figure 1, Item 9), small washer first, on shaft of shaft and lever
assembly (Figure 1, Item 2).
6.
Using snap ring pliers, install new retaining ring (Figure 1, Item 10) on shaft of shaft and lever
assembly (Figure 1, Item 2).
7.
Install woodruff key (Figure 1, Item 13) into shaft of shaft and lever assembly (Figure 1, Item 2).
8.
Install remote control lever (Figure 1, Item 12) on shaft and lever assembly (Figure 1, Item 2).
9.
Tighten cap screw (Figure 1, Item 11) securing remote control lever (Figure 1, Item 12) to shaft and lever
assembly (Figure 1, Item 2).
10.
Install two fuel rods (Figure 1, Item 6) through tubes (Figure 1, Item 1) onto upper and lower connection of
shaft and lever assembly (Figure 1, Item 2).
11.
Install washer (Figure 1, Item 3) on each connection of shaft and lever assembly (Figure 1, Item 2).
12.
Install pin (Figure 1, Item 4) on each connection of shaft and lever assembly (Figure 1, Item 2).
END OF TASK
END OF WORK PACKAGE
0102-4