TM 55-2815-574-24
SUSTAINMENT MAINTENANCE
ENGINE
BLOWER REMOVAL AND INSTALLATION
INITIAL SETUP:
Tools and Special Tools
Equipment Condition (cont.)
General mechanic's tool kit
Main navigation mast removed
(WP 0179, Table 1, Item 130)
(TM 55-1925-205-10)
Chemical gloves (WP 0179, Table 1, Item 52)
Operator's cab removed (TM 55-1925-205-10)
Eye bolts (WP 0179, Table 1, Item 12)
Intake plenum removed (TM 55-1925-205-10)
Industrial goggles (WP 0179, Table 1, Item 54)
Powered section engine hatch removed
Ratcheting torque wrench, dial,
(TM 55-1925-205-23)
1/4-in. drive, 0-75 in-lb
Engine cool to touch
(WP 0179, Table 1, Item 140)
Crankcase breather limiter assembly removed
Sling, 5,300 lb, 6 ft (green)
(WP 0179, Table 1, Item 118)
Air inlet collector assembly removed (WP 0104)
Socket wrench set, 3/8 in. sqdr,
Cylinder head poppet valve rocker arm covers
(WP 0179, Table 1, Item 135)
removed (WP 0049)
Torque wrench, 150750 in-lb (1785 Nm)
Fresh water cooling system drained (WP 0133)
(WP 0179, Table 1, Item 142)
Fresh water cooling system bypass tube removed
Fuel pump removed (WP 0094)
Materials/Parts
Air intake housing removed (WP 0103)
Automotive and artillery grease
Tachometer sending unit removed (WP 0167)
(WP 0178, Table 1, Item 21)
Blower shaft and spring assembly removed
Gasket (WP 0180, Table 1, Item 23)
Spray adhesive (WP 0178, Table 1, Item 4)
Electronic governor rod assembly removed
Electronic governor actuator removed (WP 0098)
Personnel Required
Engineer 88L
References
Equipment Condition
Single channel ground and airborne radio system
(SINCGARS) antenna removed
(TM 11-5820-890-10-8)
0110-1