TM 55-2815-574-24
0111
ASSEMBLE - Continued
Figure 11.
a.
On the bed of the arbor press, support rotor (Figure 11, Item 3) on wooden blocks with seal shaft
facing up.
b.
Start the oversize seal sleeve (Figure 11, Item 2) on the rotor shaft, and place seal installer
(Figure 11, Item 1) against the oversize seal sleeve (Figure 11, Item 2).
c.
Lower the ram of the press until either the shoulder of the installer J 35787-1 or the oversize seal
sleeve (Figure 11, Item 2) contacts the rotors (Figure 11, Item 3).
d.
Install remaining oversize seal sleeves (Figure 11, Item 2) on rotors (Figure 11, Item 3 in the same
manner.
e.
Support the end plate (Figure 7, Item 2 and Figure 7, Item 3) on wooden blocks with the finished
side facing up on the arbor press.
Figure 12.