TM 55-2815-574-24
SUSTAINMENT MAINTENANCE
ENGINE
BLOWER DRIVE ASSEMBLY REMOVAL AND INSTALLATION
INITIAL SETUP:
Tools and Special Tools
Equipment Condition (cont.)
General mechanic's tool kit
Main navigation mast removed
(WP 0179, Table 1, Item 130)
(TM 55-1925-205-23)
Socket wrench set, 3/8 in. sqdr
Intake plenum or operator's cab removed
(WP 0179, Table 1, Item 135)
(TM 55-1925-205-23)
Torque wrench, 150750 in-lb (1785 Nm)
Powered section engine hatch removed
(WP 0179, Table 1, Item 142)
(TM 55-1925-205-23)
Engine cool to touch
Cylinder head poppet valve rocker arm covers
Materials/Parts
removed (WP 0049)
Gasket (WP 0180, Table 1, Item 69)
Crankcase breather limiter assembly removed
Air inlet collector assembly removed (WP 0104)
Personnel Required
Fuel pump removed (WP 0094)
Engineer 88L
Air intake housing removed (WP 0103)
Electronic governor rod removed (WP 0097)
References
Electronic governor actuator removed (WP 0098)
TM 55-1925-205-10
Blower driveshaft removed (WP 0109)
Blower removed (WP 0110)
Equipment Condition
Single channel ground and airborne radio system
(SINCGARS) antenna removed
(TM 11-5820-890-10-8)
0112-1