TM 55-2815-574-24
0110
INSTALLATION - Continued
WARNING
Fuel/Oil may cause irritation to eyes or skin. Wear protective goggles, gloves, and clothing.
Failure to comply may result in personnel injury or death.
15.
Connect oil pressure line (Figure 1, Item 1) to fitting in rear of blower (Figure 1, Item 2) and blower drive
support (Figure 1, Item 10).
END OF TASK
FOLLOW-ON MAINTENANCE
1.
2.
Install electronic governor rod assembly (WP 0097).
3.
Install blower shaft and spring assembly (WP 0109).
4.
5.
6.
7.
Install cylinder head poppet valve rocker arm covers (WP 0049).
8.
9.
Install crankcase breather limiter assembly (WP 0106).
10.
Install fresh water cooling system bypass tube (WP 0143).
11.
12.
Install powered section engine hatch (TM 55-1925-205-23).
13.
Install operator's cab (TM 55-1925-205-10).
14.
Install intake plenum (TM 55-1925-205-10).
15.
Install main navigation mast (TM 55-1925-205-10).
16.
Install SINCGARS antenna (TM 11-5820-890-10-8).
17.
Perform operational check of diesel engine (TM 55-1925-205-10).
END OF TASK
END OF WORK PACKAGE
0110-5/blank